Use Modifiers to select temperatures for the Timed Cycles only.
Press Temperature until the desired temperature setting
illuminates. Temperature modifiers cannot be used with the Auto
Use the Air Only Modifier for items that require drying without
heat such as rubber, plastic and heat-sensitive fabrics. This table
shows examples of items that can be dried using Air Only.
Type of Load
Foam rubber - pillows, padded bras, stuffed toys
Plastic - Shower curtains, tablecloths
Olefin, polypropylene, sheer nylon
* Reset cycle to complete drying, if needed.
When using Air Only
Check to see that coverings are securely stitched.
Shake and fluff pillows by hand periodically during the cycle.
Dry item completely. Foam rubber pillows are slow to dry.
NOTE: Air Only is not available with Auto Cycles.
You can customize your cycles by selecting options.
unload the dryer promptly at the end of a cycle. During this
option, the dryer stops tumbling and then tumbles again for a
Press WRINKLE GUARD
free, periodic tumbling at the end of a cycle.
Stop WRINKLE GUARD
NOTE: If you do not select WRINKLE GUARD
after cool down.
The Cycle Signal produces an audible sound when the drying
cycle is finished. Promptly removing clothes at the end of the
cycle reduces wrinkling.
Press CYCLE SIGNAL to turn the signal off.
20 - 30
NOTE: When WRINKLE GUARD
Signal is on, a tone sounds every 5 minutes until the clothes are
20 - 30
removed, or WRINKLE GUARD
40 - 50
Changing Cycles, Options and Modifiers
10 - 20
You can change Auto Cycles, Timed Cycles, Modifiers and
Options anytime before pressing Start.
Three short tones sound if an unavailable combination is
selected. The last selection will not be accepted.
Changing Cycles after pressing Start
1. Press STOP twice. This ends the current cycle.
2. Select the desired cycle and options.
3. Press and hold START. The dryer starts at the beginning of
the new cycle.
NOTE: If you do not press Start within 5 minutes of selecting the
cycle, the dryer automatically shuts off.
Changing Modifiers and Options after pressing Start
You can change a Modifier or Option anytime before the selected
Modifier or Option begins.
1. Press STOP once.
2. Select the new Modifier and/or Option.
3. Press and hold START to continue the cycle.
NOTE: If you happen to press Stop twice, the program clears and
your dryer shuts down. Restart the selection process.
prevents wrinkles that form when you cannot
to get up to 90 minutes of heat-
at any time by pressing WRINKLE
or opening the dryer door.
is selected and the Cycle
, the dryer stops