PROCEDURE 8
OPTIONAL ANTI-TIPPER
T-3 TITANIUM AND T-4 TITANIUM ONLY(FIGURE 2)
Replacement.
1. Loosen the set screw on the anti-tipper headtube.
2. Slide the swivel caster down and out of the head tube.
3. Insert the new swivel caster up through the head tube.
4. Adjust the swivel caster. refer to adjusting in this procedure.
Adjusting.
1
Loosen the set screw on the anti-tipper headtube.
2. Adjust the anti-tipper swivel caster to 1/2 to 1/4-inches from the floor.
3. Tighten the set screw on the anti-tipper headtube.
ASSEMBLED
DISASSEMBLED
Headtube
Headtube
Set Screw
Swivel Caster
Swivel Caster
Rear Swivel Caster
1/4 to 1/2-inch
Clearance
FIGURE 2 - REPLACING/ADJUSTING FIXED ANTI-TIPPER SWIVEL CASTER
- T-3 TITANIUM AND T-4 TITANIUM ONLY
60
T-3™ and T-4™ Series
Part No. 1054916