Adjusting Quick-Release Axles - Invacare Top End T-3 Tennis Adjustable Operating And Maintenance Manual

WHEELS
Make sure the detent pin and locking pins of the quick/quad-release axle are
fully released BEFORE operating wheelchair.
The locking pins MUST be protruding past the inside of the rear wheel axle
bushing for a positive lock.
Keep locking pins clean.
4. If the locking pins are not protruding past the inside of the axle bushing or there is too
much movement of the rear wheel assembly in a back and forth motion, refer to ADJUST-
ING QUICK-RELEASE AXLES or ADJUSTING QUAD-RELEASE HANDLES in this proce-
dure of the manual.
Quad-Release Axle
Handle
FIGURE 1 - REMOVING/INSTALLING REAR WHEELS
ADJUSTING QUICK-RELEASE AXLES (FIGURE 2)
1. Remove rear wheel and quick-release axle from chair.
2. Depress detent pin in the quick-release axle and slide axle through the wheel hub.
3. Release detent pin ensuring that locking pins are fully released.
4. Increase or decrease end play by adjusting knurled locking collar or locknut on the end of the
quick-release axle.
Make sure detent pin and locking pins of the quick-release axles are fully re-
leased BEFORE operating the wheelchair.
Keep locking pins clean.
5. Reinstall rear wheel onto the chair.
Adjustable Axle Position
NOTE: End of Quick Release axle is shown
for reference only. It is not visible when in-
serted into camber bar.
FIGURE 2 - ADJUSTING QUICK-RELEASE AXLES
Part No. 1054916
WARNING
QUAD-RELEASE AXLE
Detent Pin
WARNING
Camber Bar
Locking
Pins
Quick
Release Axle
31
PROCEDURE 6
Camber Insert
Rear Wheel Hub
Locknut
Detent Pin
Wheel Hub
T-3™ and T-4™ Series