Nylon Clothing Guard With Plastic Insert Replacement; Rigid Clothing Guard Replacement - Invacare Top End T-3 Tennis Adjustable Operating And Maintenance Manual

CLOTHING GUARDS
This Procedure includes the following:

Nylon Clothing Guard With Plastic Insert Replacement

Rigid Clothing Guard Replacement

After ANY adjustments, repair or service and BEFORE use, make sure all attach-
ing hardware is tightened securely - otherwise injury or damage may result.
NYLON CLOTHING GUARD WITH PLASTIC INSERT
REPLACEMENT (FIGURE 1)
1. Lift up on the seat cushion and remove it
from the chair.
2. Separate the nylon clothing guard with
plastic insert from the seat and back
upholstery.
3. Install NEW nylon clothing guard with
plastic insert onto the seat and back
upholstery.
NOTE: The fastening flaps that secure the nylon
clothing guards to the back upholstery wrap around
the outside of the back canes.
4. Reattach the seat cushion to the seat
upholstery.
RIGID CLOTHING GUARD REPLACEMENT (FIGURE 2)
1. Remove rear wheels if necessary. Refer to REMOVING/INSTALLING REAR WHEELS in
PROCEDURE 6 of this manual.
2. Remove seat cushion from chair.
3. Install the clothing guard clamps to the
chair as shown in FIGURE 2 with the
outer clamp located onto the outside of
the seat rail and the inner clamp on the
inside of the seat rail.
4. Assemble the clamps together with allen
screw and washer provided.
5. Adjust clamp assembly forward or rear-
ward to desired position.
6. Install rigid clothing guard by inserting
stem into clamp assembly.
7. Repeat steps for other side of chair.
Part No. 1054916
WARNING
Nylon Clothing Guard With
Plastic Insert
FIGURE 1 - NYLON CLOTHING
GUARD WITH PLASTIC INSERT
REPLACEMENT
Stem
Outer Clamp
FIGURE 2 - RIGID CLOTHING
GUARD REPLACEMENT
29
PROCEDURE 5
Fastening Flaps
Back Cane
Rigid Clothing Guard
Washer
Inner Clamp
Allen
Screw
Seat Rail
T-3™ and T-4™ Series