Removing Play From Rear Wheels - Invacare Top End T-3 Tennis Adjustable Operating And Maintenance Manual

WHEELS
ADJUSTING (FIGURE 4)
Adjusting Quad-Release Handles In And/Or Out.
1. Remove rear wheel and quad-release axle from the chair, refer to REMOVING/INSTALL-
ING THE REAR WHEELS in this procedure of the manual.
2. Loosen the locking screw.
3. Make the following adjustments if necessary:
A. If the quad-release handle is not releasing the locking pins completely, rotate the
quad-release handle approximately one-quarter (1/4) turn CLOCKWISE.
B. If the quad-release handle hits the spokes of the rear wheel when assembled, rotate the
quad-release handle approximately one-quarter (1/4) turn COUNTERCLOCKWISE.
4. Tighten the locking screw.
5. Reinstall rear wheel and quad-release axle onto the chair.
Make sure detent pin of the quad-release axle is fully released BEFORE operat-
ing the wheelchair.
Keep locking pins clean.
6. Flip handle of the quad-release axle down to release the detent pin ensuring that the
locking pins are fully released.
7. Repeat the above procedures until the quad-release axle locks correctly.

Removing Play From Rear Wheels.

1. With the rear wheel and quad-release axle still mounted onto the chair, make the follow-
ing adjustment:
A. Tighten length adjusting screw until there is no in and out movement of quad-release
axle and rear wheel.
Quad-Release Handle
Locking
Screw
ADJUSTING QUAD-RELEASE HANDLE
IN OR OUT
FIGURE 4 - ADJUSTING QUAD-RELEASE AXLES
Part No. 1054916
WARNING
Locking Pins
Camber Insert
REMOVING PLAY
FROM THE REAR
33
PROCEDURE 6
WHEELS
Reduces Play
T-3™ and T-4™ Series
Length
Adjustment
Screw