Removing Play From Rear Wheels; Preventing Play In Rear Wheels; Adjusting Quick-Release Axles - Invacare Top End T-5 7000 Series User Manual

Top End® Sports Series

5.6 Removing Play from Rear Wheels

WARNING!
RISK OF INJURY OR DAMAGE
– After any adjustments, repair or service and before
use, make sure all attaching hardware is tightened
securely. Otherwise injury or damage may occur.
With the rear wheel and quad-release axle still mounted onto the
wheelchair, make the following adjustment:
•
Tighten the length adjusting screw until there is no in and out
movement of the quad-release axle and rear wheel.

5.7 Preventing Play in Rear Wheels

To prevent play in rear wheels install the rear wheel bolt securing
lock washer system.
Attach camber clamp D to wheelchair frame C.
1.
Insert bolt E through camber clamp D and tighten securely.
2.
Place washer A between axle receiver and nut assembly B and
3.
wheelchair frame C.
Tighten axle receiver and nut assembly B securely.
4.
42

5.8 Adjusting Quick-Release Axles

1. Remove rear wheel and quick-release axle A from the
wheelchair.
Depress detent pin D in the quick-release axle A and slide axle
2.
through the wheel hub.
Release detent pin D ensuring that the locking pins C are fully
3.
released.
Increase or decrease end play by adjusting the locknut B on the
4.
end of the quick-release axle A.
5. Install the rear wheel onto the wheelchair and ensure the wheel
is securely engaged.
Quad-Release Axle not shown. Locking pins on the
Quad-Release Axle are the same as Quick-Release Axle.
1171910-A~15