Table of Contents
Advertisement
Invacare® AVIVA™ FX Series
1. Make sure mobility device is powered down.
2. Remove side shrouds.
3. Remove screws B securing side panel shroud C to
frame.
4. Remove side panel shroud.
5. Install parts in reverse order.
6.6.6 Replacing Fender
CAUTION!
Risk of Crushing to Hands and Feet by Weight of Component
Heavy components may cause injury or damage if dropped or not properly secured.
– Pay attention to hand and feet.
– Use proper lifting techniques.
– Properly secure heavy equipment or components when servicing.
CAUTION!
Risk of Uncontrolled Movement of Mobility Device
Uncontrolled movement of the mobility device can cause injury or damage.
– Power down mobility device.
– Engage drive.
– Before raising mobility device, secure wheels by blocking them with wedges.
– Prevent the mobility device from tipping by propping it up on wooden blocks which are long and wide enough
under the battery case. If the wooden blocks are too short or too high, the mobility device can still tip.
•
4 mm Allen key
•
10 mm wrench
•
Torque wrench
1. Make sure mobility device is powered down.
2. Remove drive wheel. Refer to 6.8.6 Replacing Drive
Wheel (1–Bolt Installation), page 37.
3. Remove screws A securing fender bracket C to
gearbox.
4. Remove nuts E securing fender B and light bracket
D (if present) to fender bracket C.
5. Remove fender.
6. Install parts in reverse order.
Tighten the hardware as listed below:
•
Fender bracket C to 4 Nm
•
Gearbox screws A to 18 Nm
6.6.7 Replacing Rim Cap and Insert (Drive Wheel)
•
Flat screwdriver
24
Fig. 6-9 Seat assembly not shown for clarity.
D E
B
C
A
Fig. 6-10
1675507-A
Advertisement
Table of Contents
