2
1
2
EAS00317
REMOVING THE PRIMARY SHEAVE
1. Remove:
• primary sheave nut 1
• conical spring washer
• kickstarter one-way clutch
• claw washer
• primary fixed sheave 2
NOTE:
3
@
While holding the generator rotor with the rotor
holding tool 3, loosen the primary sheave nut.
EAS00319
DISASSEMBLING THE SECONDARY
PULLEY
1. Remove:
1
• clutch carrier nut 1
NOTE:
@
Install the clutch spring holder 2 onto the sec-
ondary pulley as shown. Then, compress the
spring, and remove the clutch carrier nut 1.
EAS00291
CHECKING THE CLUTCH SHOES
The following procedure applies to all of the
clutch shoes.
1. Check:
• clutch shoe
Damage/wear → Replace the clutch shoes
as a set.
Glazed areas → Sand with course sandpa-
per.
NOTE:
@
After sanding the glazed areas, clean the
clutch with a cloth.
5 - 20
BELT DRIVE
Rotor holding tool
YU-01235
Clutch spring holder
YS-28891
ENG