Removing The Secondary Pulley And V-Belt - Yamaha YJ50RAP Service Manual

1
2
1
BELT DRIVE
EAS00318
REMOVING THE SECONDARY PULLEY
AND V-BELT
1. Remove:
2
• air shroud
• fan
Refer to "GENERATOR AND AUTOLUBE
PUMP".
3
2. Remove:
• clutch housing nut 1
• clutch housing 2
NOTE:
@
While holding the clutch housing with the
sheave holder 3, loosen the clutch housing
nut.
3. Remove:
• secondary pulley 1
• V-belt 2
NOTE:
@
Pull the secondary sliding sheave out as
shown, remove the V-belt from the primary
pulley, and then remove the secondary pulley
1
1 along with the V-belt 2.
4. Loosen:
• clutch carrier nut 1
CAUTION:
@
Do not remove the clutch carrier nut at this
stage.
2
NOTE:
@
While holding the clutch carrier with the rotor
holding tool 2, loosen the clutch carrier nut
one full turn with the locknut wrench.
5 - 19
ENG
Sheave holder
YU-01701
Rotor holding tool
YU-01235
Locknut wrench
90890-01348