Yamaha YJ50RAP Service Manual page 17

Tool No.
YU-01701
YU-03112
YU-33223
YU-33975
YU-8036-A
Crankshaft installer tool
set
YU-90050
Crankshaft installer pot
YU-90058
Crankshaft installer bolt
YU-90060
YU-90062
YU-90105
Tool name/Function
Sheave holder
This tool is used to hold the clutch hous-
ing when removing or installing the
clutch housing nut.
Pocket tester
This tool is used to check the electrical
system.
Compression gauge
This tool is used to measure engine
compression.
Steering nut wrench
This tool is used to loosen or tighten the
steering stem ring nut.
Inductive tachometer
This tool is used to check engine speed.
Crankshaft installer tool set
Crankshaft installer pot
Crankshaft installer bolt
These tools are used to install the
crankshaft.
Crankshaft installer adaptor (M10)
This tool is used to install the crank-
shaft.
Flywheel puller set
This tool is used to remove the genera-
tor rotor.
SPECIAL TOOLS
1 - 6
GEN
INFO
Illustration