Special Tools - Yamaha YJ50RAP Service Manual

EAS00027

SPECIAL TOOLS

The following special tools are necessary for complete and accurate tune-up and assembly. Use
only the appropriate special tools as this will help prevent damage caused by the use of inappropri-
ate tools or improvised techniques. Special tools, part numbers or both may differ depending on the
country.
When placing an order, refer to the list provided below to avoid any mistakes.
Tool No.
YM-01409
YM-01411
YM-34487
YS-28891
YU-01135
YU-01235
YU-01444
Tool name/Function
Oil seal guide
This tool is used to install oil seals.
Crankshaft installer spacer
This tool is used to install the crank-
shaft.
Dynamic spark tester
This tool is used to check the ignition
system components.
Clutch spring holder
This tool is used to disassembly and
assembly the secondary pulley.
Crankcase separating tool
This tool is used to remove the crank-
shaft and to separate the crankcase.
Rotor holding tool
This tool is used to hold the generator
rotor when removing or installing the
generator rotor bolt.
Steering nut wrench (45 mm)
This tool is used to loosen and tighten
the lower steering stem nut.
SPECIAL TOOLS
1 - 5
GEN
INFO
Illustration