Factory Default Settings - Intermec EasyCoder 4420 User Manual

Appendix A — Specifications

Factory Default Settings

78
Printhead
4420
Width
112 mm maximum (4.4 in)
Printed dot size 0.127 mm (0.00492 in square)
Resolution 8 dots per mm (203 dots per in)
*Number of elements 896 per printhead
"X" dimensions 10 mil to 500 mil (0.25 mm to 12.7 mm); 5 mil (0.13 mm) in drag
mode only (specified media only)
4440
Width
112 mm maximum (4.4 in)
Printed dot size 0.065 mm (0.00246 in square)
Resolution 16 dots per mm (406 dots per in)
*Number of elements 1792 per printhead
"X" dimensions 5 mil to 500 mil (0.127 mm to 12.7 mm) (specified media only);
2.5 mil (0.06 mm) in drag mode only (specified media only)
Printing Method
The printers are capable of direct thermal (DT) printing or thermal
transfer (TTR) printing using a thermal transfer ribbon.
Printing Speed
*
Maximum 254 mm per second (10 inches per second), on specified media only
*Minimum 51 mm per second (2 inches per second)
The print speed can be changed in 1 ips increments only. Note that the
printer cannot print at 228.6 mps (9 ips).
Ribbon Specifications
Length 450 m (18,000 linear inches)
Widths 54 mm (2.1 in)
76 mm (3.0 in)
104 mm (4.1 in)
114 mm (4.5 in)
*Diameter 81 mm (3.2 in) maximum
The following table lists the factory default settings for the 4420 and 4440
printer. Use PrintSet to set these parameters. The printer's default serial
port settings are described in Chapter 2, "Installing the Printer."
EasyCoder 4420 and 4440 Bar Code Label Printer User's Manual