SOLTEK SL-85DR-C User Manual page 69

IDE HDD Block Mode Block mode is also called block transfer, multiple
Power ON Function This option allows you to select <KB Power ON
KB Power ON Pass-
word
Hot-Key Power ON Boot up the system via predetermined keyboard hot
Onboard FDC
Controller
Onboard Serial
Port 1 / Port 2
UART Mode Select The serial ports on your system offer a variety of
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives
do), select Enabled for automatic detection of the
optimal number of block read/write per sector the
drive can support.
The choices: Enabled; Disabled.
Password> , <Hot-Key Power ON> or others.
The choices: Any Key, Button only, Keyboard 98,
Password, Hot-Key, Mouse Move, Mouse Click.
When user sets a password for keyboard, the
password user set that return the system to Full
On state.
key.
The choices: <Ctrl>+<F1>...<F12>
Select Enabled if your system has a floppy drive
controller (FDC) installing in the system board and
you want to use it. If you install add-in FDC or your
system has no floppy drive, select Disabled.
The choices: Enabled (default); Disabled.
Select a logical COM port name and matching
address for the first and second serial ports.
Select an address and corresponding interrupt
for the first and second serial ports. Choices:
Auto(default); Disabled; 3F8/IRQ4; 2F8/IRQ3;
2E8/IRQ3.
infrared port modes of the Universal Asynchronous
Receiver/Transmitter.
The choices: Normal; IrDA; ASKIR.
69
Chapter 4 BIOS Setup