Table of Contents
Advertisement
PLEASE READ THESE INSTRUCTIONS CAREFULLY BEFORE ASSEMBLY AND USE.
FAILURE TO FOLLOW THESE INSTRUCTIONS COULD RESULT IN DEATH, SERIOUS
BODILY INJURY, AND/OR PROPERTY LOSS. READ AND FOLLOW ALL INSTRUCTIONS
CAREFULLY BEFORE ASSEMBLY OR USE OF THIS OUTDOOR GAS GRILL.
WARNING! Read and follow all instructions. Retain these instructions for future reference.
Installation must conform with local codes, or in the absence of local codes, to the National Fuel
Gas Code, ANSI Z223.1/NFPA 54, or the CSA-B149.1, Natural Gas and Propane Installation code.
This gas grill is for use only outdoors. DO NOT use inside a building, garage, or any other
enclosed area.
This outdoor gas grill is not intended to be installed in or on recreational vehicles and/or boats.
This outdoor gas grill should not be located under overhead combustible construction and proper
clearances must be maintained at all times from combustible construction and/or materials, with
MINIMUM clearances as follows:
From Sides – 36 in. (91 cm)
From back – 36 in. (91 cm)
Place in a well-ventilated area.
Inspect the hose before each use.If there is evidence of excessive abrasion or wear, or the hose is cut,
do not operate grill. Use only the pressure regulator and hose supplied with this grill.
WARNING! If your outdoor gas grill catches on fire, use an ABC fire extinguisher to extinguish the
fire. Never attempt to extinguish a grease fire with water or other liquids. Turn off all control
knobs on outdoor gas grill and LP cylinder valve if they can be reached safely. If you cannot
safely reach the control knobs or LP cylinder valve to stop the flow of gas that can feed the fire,
evacuate the area and call the fire department
This gas grill is not designed to be used with natural gas. Conversion to natural gas should NOT
be attempted as it will create an unsafe situation.
This gas grill should not be connected to any gas supply other than a Type 1 compatible propane gas
cylinder. Connection to home gas lines will result in poor performance of the grill and may result
in an unsafe condition.
Any LP gas supply cylinder used with this grill must be approximately 12 in. (30.5 cm) diameter
and 18 in. (45.7 cm) high. The maximum fuel capacity is 80 percent and is approximately 20
pounds (9 kg) of propane. The maximum weight of a properly filled cylinder is approximately 38
pounds (17.2 kg) <47.7 lbs. (21.6kg) nominal water capacity>. The LP cylinder must have a shut-off
valve terminating in a Type 1 LP gas cylinder valve outlet.
Any LP gas cylinder used with this gas grill must be constructed and marked in accordance with the
specifications for LP gas cylinders of the U.S. Department of Transportation (DOT) or the National
Standard of Canada, CAN/CSA-B339, Cylinder, Spheres and Tubes for Transportation of
Dangerous Goods; and Commission, as appliance; and must be provided with a listed overfilling
prevention device.
The LP gas cylinder must be a Type 1 compatible cylinder with a Type 1 cylinder valve that has a
back-check valve, which does not permit gas flow, until a positive seal has been obtained.
The cylinder must be arranged for vapor withdrawal. It must also include a collar to protect the
cylinder valve. A safety relief device having direct communication with the vapor space of
cylinder must be provided. This will expel high-pressure gas if the cylinder is overfilled or
overheated which could result in fire or explosion.
The gas must be turned off at the cylinder when the outdoor gas grill is not in use.
WARNINGS
2
Advertisement
Table of Contents
