Table of Contents
Advertisement
Step 9
REQUIRES TWO PEOPLE
-
Remove cardboard sleeve and wire ties from the hose and regulator assembly and allowing it to hang
from the fire body.
-
Carefully lower the fire body (1) onto the cart. Hook the slots on the rear edges of the fire body
over the bolts on the rear legs. Please see inset diagram for better understanding.
-
Raise the front of fire body slightly and carefully align the bolt holes on the legs with the threaded
inserts on the side of the firebox, to allow for insertion of bolts A (4 pcs.) to the front legs. Insert
bolts and screw them in only enough to secure the firebox to the cart. Do not tighten.
-
Insert rear bolts A (2 pcs.) to the rear legs following the above instructions. You will tighten all
bolts later.
NOTE:
Beware of sharp metal edges and be sure to wear protective gloves to prevent possible injury
during this step of assembly.
Lock the casters in advance before lowering the fire body onto the cart assembly to keep the cart
from rolling away.
15
Advertisement
Table of Contents
