Table of Contents
Advertisement
MAIN BURNER AND SIDE BURNER WITH RESPECT TO PROPER
LOCATION: WARNING – ALWAYS CHECK TO ENSURE BURNERS ARE
POSITIONED CORRECTLY BEFORE EACH USE
Ensure main burners are installed as shown.
CONNECTING THE GAS
Connecting to a Gas Cylinder
1. Ensure all control knobs are in the OFF position and verify that the LP gas cylinder valve is closed by turning the
handle on the LP gas cylinder valve clockwise until it stops.
2. Remove the protective cap from the LP cylinder valve nozzle.
3. Hold regulator in a straight line with LP cylinder valve nozzle so the connection does not cross thread.
4. Insert regulator nipple into the LP cylinder valve nozzle opening.
5. Hand-tighten coupling nut in a clockwise direction. Do not use tools!
6. Perform a Leak Test. (See Leak Testing section of this manual).
Disconnecting the Gas Cylinder
1. Turn all control knobs to the OFF position and turn
the handle on the LP gas cylinder clock-wise until it stops.
2. Turn coupling nut on regulator in a counter-clockwise direction
until regulator is released from threaded LP cylinder valve nozzle.
3. Place dust cap on cylinder valve outlet whenever the cylinder is not in use. Only install the type of dust cap on the
cylinder valve outlet that is provided with the cylinder valve. Other types of caps or plugs may result in leakage of
propane.
LEAK TESTING
Always perform a leak test in a well-ventilated area.
Step 1- Confirm all control knobs are in the off position.
Step 2- Turn on the gas at the gas cylinder.
Step 3- Check for leaks by brushing a solution of
including valve connections, hose connections, and regulator connections.
Step 4- If bubbles form over any of the joints there is a leak
Turn off the gas
Retighten all joints
Repeat test
If bubbles form again, do not use the grill and contact your gas supplier or fire department for assistance.
Ensure side burner is installed as shown.
1
1
/
water and
/
liquid detergent over all the gas system joints,
2
2
24
Advertisement
Table of Contents
