Messages For Navigation Functions - Pioneer AVIC-F50BT Operation Manual

Appendix

Messages for navigation functions

The following messages may be displayed by your navigation system. Refer to the table to identify
the problem, then take the suggested corrective action.
There are occasions when you may see error messages other than those shown here. In such
cases, follow the instructions given on the display.
Message
Route calculation was not
possible.
Route calculation not possi-
ble: destination is too far.
Route calculation not possi-
ble: destination is too close.
Route calculation not possi-
ble: navigation cannot be pro-
vided around destination or
starting point.
Unable to find any road lead-
ing to destination
Failed to make the route pro-
file.
No image file.
Unsupported file format.
An anomaly was detected on
the speaker output. Please
turn the Ignition OFF/ON to
restart. If the problem per-
sists, Please contact your
Pioneer dealer or Service Cen-
ter.
Cause
Route calculation has failed be-
cause of a malfunction in the map
data, software, or hardware.
The destination is too far.
The destination is too close.
The destination, waypoint(s), or
starting point are in an area where
no road exists (e.g. a mountain) and
the route calculation is impossible.
The destination or waypoint(s) are in
an isolated island, etc. without a
ferry and the route calculation is im-
possible. If there is no road con-
nected to your starting point or
destination, this message will ap-
pear.
In rare cases, a route calculation
error may occur.
"Pictures" folder exists on the SD
memory card but there is no load-
able data in the folder.
An image file was not made to spe-
cifications as the splash screen.
This unit fails to operate or the
speaker connection is incorrect; the
protective circuit is activated.
Action (Reference)
! Change the destination.
! Consult the Pioneer Local dealer if this mes-
sage persists.
Set a destination closer to the starting point.
Set a destination farther from the starting
point.
! Set a destination and waypoint(s) on roads.
! Reset the destination after you drive the ve-
hicle to any road.
Change the destination.
! Retry.
! Consult the Pioneer Local dealer if this mes-
sage persists.
Use appropriate data and store it correctly.
(Page 145)
Use appropriate data and store it correctly.
(Page 145)
Check the speaker connection. If the mes-
sage fails to disappear even after the engine
is switched off/on, contact your dealer or an
authorised Pioneer Service Station for assis-
tance.
Appendix
175
Engb