Usb Configuration - Intel ICH10R User Manual

Set it as enabled if you wish to resume the system by keyboard. The optional setting is :
Enabled; Disabled.
Power On by Mouse
Set it as enabled if you wish to resume the system by mouse. The optional setting is : Enabled;
Disabled.
Serial Port1 /Port 2 Address
Use this item to select serial port address for serial port one.
Serial Port2 Mode
The optional settings are: Normal; IrDA (1.6 ns); IrDA(3/16 bit).
PWRON After PWR-Fail
The optional settings are: Always On; Always Off and Former-Sts.

3-7-4 USB Configuration

CMOS Setup Utility-Copyright(C)1985-2005 American Megatrends. Inc.
USB Configuration
Module Version -2.24.3-13.4
USB Devices Enabled
None
Legacy USB Support
Port 64/60 Emulation
USB 2.0 Controller Mode
BIOS EHCI Hand-Off
Hotplug USB FDD Support
↑↓→← Move Enter:Select +/-/PU/PD:Value F10:Save ESC:Exit F1:General Help
F5:Discard Changes
Port 64/60 Emulation
Enables I/O put 64h/60h emulation support. This should be enabled for the complete USB
keyboard legacy support for non-USB aware OSes. The optional settings are: Enabled;
Disabled.
USB 2.0 Controller Mode
This item configures the USB 2.0 controller in the Hi-Speed (480Mbps) or Full-Speed (12
Mbps) mode.
BIOS EHCI Hand-Off
This is a workaround for OSes without EHCI hand-off support. The EHCI ownership change
should claim by EHCI driver.
Hotplug USB fdd Support
A dummy FDD device is created that will be associated with the hotplug FDD later. Auto
option creates this dummy device only if there is no USB FDD present.
USB Configuration
Enabled
Disabled
HiSpeed
Enabled
Auto
F6:Fail-Safe Defaults
32
Help Item
Enables support for legacy
USB. AUTO option
Leacy support If no USB devices
are connected
F7:Optimized Defaults
disables