Faq - Philips ProntoPro User Manual

FAQ

Can I program a button to execute more than one command?
With the Remote Control you can only create a macro to execute a sequence of commands (see p. 31). But you can
program a button to execute more than one command with ProntoPro Edit.
How do I program source switching?
See "Learning Device Actions" on page 24.
How can I program, label or delete buttons on the Home panel?
You can do this via the Device menu. All changes you make to the devices in the Device menu are automatically
updated on the Home panel.
Can I recharge the Remote Control any time I want?
Yes, you can. It is not necessary to use the Remote Control until the battery pack has ran out completely. The docking
station is the most suitable place for the Remote Control when not in use.
How do I reset the Remote Control?
Under normal circumstances, you will never have to reset the Remote Control. However, on rare occasions, if the
Remote Control's touch screen freezes or if you notice unusual behavior, you need to perform a reset to get the Remote
Control running again. All saved programmed commands or macros are retained.
1. Slide the battery cover off the back of the Remote Control.
You will see the Reset button in the battery compartment.
2. Use an unfolded paperclip or a sharp pencil to carefully press the Reset button.
The Remote Control restarts and a Introduction screen appears. The Remote Control beeps twice to indicate it is
ready for use.
How do I revert to the original configuration?
Reverting to the original configuration restores the Remote Control's devices and commands to its state when you
purchased it. This means that all programming is lost permanently. Normally, you never have to revert the Remote
Control.
1. Touch and hold the Remote Control icon for a few seconds.
The first setup panel appears.
2. Scroll to the second setup panel.
3. Tap the Revert button.
4. Tap Revert to confirm the action.
FAQ 43