Philips ProntoPro User Manual page 45

How do I calibrate the touch screen?
The Remote Control is calibrated when it leaves the factory. It is possible you have to calibrate the touch screen:
• when the touch screen buttons do not respond properly.
Complete instructions 1 to 6 in "Calibrating the touch screen" described below.
• when the Remote Control displays a message to calibrate the touch screen.
Complete instructions 4 and 5 in "Calibrating the touch screen" described below.
Calibrating the touch screen
1. Touch and hold the Remote Control icon
The Remote Control switches to Setup mode.
2. Scroll to the second setup panel.
3. Tap the Calibrate button
The first instruction "Touch TOP LEFT corner" appears.
4. Tap as close as possible in the upper left corner using a blunt tip of a pencil.
The second instruction "Touch BUTTOM RIGHT corner" appears.
5. Tap as close as possible in the lower right corner using a blunt tip of a pencil.
The setup panel appears again.
6. Tap the Remote Control icon
The Remote Control switches to Use mode.
Why does a device respond to some RF signals and not to others?
Philips cannot guarantee that all commands for all devices work properly with RF signals.
In some cases, if a device does not respond properly to RF signals sent out by the Remote Control, you might better
reconfigure the Remote Control to operate the device with IR signals.
FAQ
for three seconds.
.
.
44