Before You Start - Philips ProntoPro User Manual

Before You Start

When you use the Remote Control for the first time, you will have to:
• install the battery pack;
• place the Remote Control in the docking station and charge the Remote Control.
Use the docking station only with the Philips NiMH rechargeable battery pack.
We strongly advise you not to plug other appliances (like mobile phones, PDA's, ...) into the docking station. This
causes damage to the connector and the appliance.
Installing the Battery Pack
1. Press the latch on the battery cover and remove the battery cover from the Remote Control.
2. Place the battery pack in the battery compartment.
3. Plug the cable of the battery pack in the connector as illustrated.
4. Place the battery cover back on.
Make sure the cable of the battery pack does not get stuck between the mould and the battery cover.
After a few seconds, the Remote Control starts up automatically and an Introduction screen appears. The Remote
Control beeps twice to indicate that it has finished starting up.
Because the battery pack of the Remote Control is not fully pre-charged, you will have to charge it as described
below.
Taking a First Look 5