Fastening The Hob - CDA CD 60 User Operating Instructions Manual

INSTALLATION ABOVE UNITS WITH DOORS
The unit must be so constructed that the movement of air caused by closing and open-
ing, even violent, of the doors does not cause the burners to go out.
Leave a depression space of 30 mm between the bottom of the hob and the top of the
unit (Fig. 11).
MOUNTING THE FASTENING TABS
Each hob is supplied with a set of tabs and screws to fasten it to units from 2 to 4 cm
thick.
Turn the hob over and put tabs "A" into the mountings; only tighten screws "B" a few
turns. Do not over tighten.
Make sure that the tabs are mounted correctly as shown in Figure 12.

FASTENING THE HOB

Stretch gasket "C" above the unit along the edge of the hole made, being careful to
overlay the joining edges.
Put the hob into the hole cut into the worktop and position it correctly.
Put tabs "A" into place and tighten screws "B" until the hob is completely secured.
Carefully trim away the excess gasket material from around the hob.
Figure 11
D e p r e s s i o n
space
Space for
connections
12
(fig. 12)
Door
(fig. 11)
(fig. 12)
Figure 12
B
C
A