Table of Contents
Related Manuals for CDA INDUCTION HOB HVN61/81
Summary of Contents for CDA INDUCTION HOB HVN61/81
- Page 1 Manual for Installation, Use and Maintenance Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...
- Page 2 Under no circumstances should any external covers be removed for servicing or maintenance except by suitably qualified personnel. Appliance information: Please enter the details on the appliance rating plate below for reference, to assist CDA Customer Care in the event of a fault with your appliance and to register your appliance for guarantee purposes. Appliance Model...
- Page 3 To avoid interference between your hob and a pacemaker, your pacemaker must be designed and programmed in compliance with the regulations that apply to it. As such, CDA guarantee only that our product is compliant. With regard to the compliance of the pacemaker or any potential incompatibility, you should obtain information from the manufacturer or your attending physician.
-
Page 4: Control Panel
Using your Hob Fig. 1 HVN61FR Zones: Front left 2.8 kW 180 mm Back left 2.8 kW 180 mm Back right 3. 1 kW 210 mm Front right 2.2 kW 160 mm Control panel: 9. Power key 10. Power level keys 11. -
Page 5: How To Use
Using your Hob To switch the zone on • Touch the key for the zone required. The zone display will flash 0 and the hob will beep to confirm the hob is on. Please note: If a power level is not set within five seconds, the zone will switch off automatically. To set the power level •... - Page 6 Please note: • When the zone display shows PC, the zone will switch off automatically after five seconds if the power level is not set. • The precook time is preset according to the power level selected. • The precook function can only be used for cooking at power levels 6-12. •...
-
Page 7: Safety Features
Safety Features The childlock The hob is equipped with a childlock to lock the controls. This can be used when the hob is off or during cooking To set the childlock Touch the key for approximately three seconds until the LED above the childlock key illuminates and the hob beeps to confirm the childlock is switched on. -
Page 8: Efficient Use
Efficient Use of your Hob The hob is equipped with zones of different sizes, designed to accommodate most shapes and sizes of pan. For best results, only use pans with flat bottoms and choose an appropriate zone depending on the size of the pan. The most ef- ficient use of the hob is shown below, where the pan and zone are correctly chosen. -
Page 9: Cleaning
2. Check that the mains supply has not been switched off. 3. Check that the fuse in the spur has not blown. In the event of a fault with the hob, please advise CDA Customer Care of any fault code shown on the display Contact CDA Customer Care A : Customer Care Department, The CDA Group Ltd, Harby Road, Langar, Nottinghamshire, NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu... -
Page 10: Troubleshooting
IMPORTANT - PLEASE NOTE: In the event of any breakage, crack or cracking – even minimal – of the vitroceramic glass, immedi- ately disconnect your appliance to prevent a risk of electric shock and contact CDA Customer Care. Possible Causes... -
Page 11: Fitting The Hob
Fitting the Hob Unpacking the hob: Take care not to lose or mishandle any parts. Fitting position of the hob: This appliance must be installed a minimum of 50mm from any back wall and a minimum of 180mm away from any adja- cent vertical surfaces, e.g. - Page 12 How to install the hob: Overall dimensions of the hob: HVN61FR: Width: 580 mm Depth: 510 mm Worktop cut-out dimensions: HVN61FR: Width: 560 mm Depth: 490 mm 1. Make the required hole in the worktop. Before doing this, you must check the instructions supplied with any cooker hood to ensure that you will have the required clearance.
-
Page 13: Mains Electricity Connection
Mains Electricity Connection Warning! this appliance must be earthed We recommend that the appliance is connected by a qualified electrician, who is a member of the N.I.C.E.I.C. and who will comply with the I.E.E. and local regulations. This appliance is intended to be connected to fixed wiring and is not suitable for connection to a 13a plug or 13a supply. - Page 16 Passionate about style Customer Care Department • The Group Ltd. • Harby Road • Langar • Nottinghamshire • NG13 9HY T : 01949 862 012 F : 01949 862 003 E : service@cda.eu W : www.cda.eu...