TYPES OF GASES
There are two types of gas suitable to use with this appliance.
G30 / G31
G20
INSTALLATION
The appliance is set at the factory to operate with the gas indicated on the rating plate
on the appliance.
If the appliance must be operated with a gas different than that indicated on the plate,
it is necessary to make the following changes:
gas connection
replacement of the injectors
regulating of the minimum flame.
GAS CONNECTION
GB
Cat: II 2H3+
The connection must be executed by a suitably qualified person according to the rele-
vant standards.
The fitting (fig. 15a and 15b) is made up of:
1 nipple "A"
1 biconical gasket ring "B"
1 elbow fitting "C"
gasket "F"
Figure 15a
C
14
Gas Section
B
A
F
Figure 15b
C
F
A
F