Checks; Servicing; General Servicing - Valor 737XN Installation And Owner's Manual

8.3. Checks

8.3.1 A periodic check of the pilot and burner flames should be made.
Check after the fire has been on for at least 30 minutes. The pilot
flame must cover the tip of the thermocouple probe. The main
burner flame pattern will vary from appliance to appliance depending
on the type of installation and climatic conditions. See figures 39 &
40.
8.3.2 The appliance area must always be kept clear and free from
combustible materials, gasoline and other flammable vapors and
liquids.
8.3.3 Keep the area in front at the bottom of the appliance clear.
Obstructions will impede the flow of air to the appliance and cause
incorrect combustion.
8.3.4 The flow of combustion and ventilation air must not be obstructed.
The venting system should be examined by a qualified agency
regularly. We suggest annually.

8.4. Servicing

All appliances use four 1.5V AA batteries for thermostat control.
For Appliances with Rocker Switch the batteries are accessible by opening the
bottom access panel.
For Appliances with Remote Control the batteries are accessible by opening the
bottom access panel and removing the lid of the remote control receiver. The
hand set has a 9V battery.

8.5. General servicing

If you require any attention to your appliance, contact your supplier quoting the model number. It will be helpful if the appliance serial
number can also be quoted. This is on the rating plate, which is on a chained, plate accessible by opening the bottom access panel.
The repair parts are shown in the separate repair parts leaflet. Please always quote part number and description when requesting spare
parts.
Fig. 39 Burner flames
Fig. 40 Pilot flame
21