Front Frame & Switch To Appliance - Valor 737XN Installation And Owner's Manual

7.6. Front frame & switch to appliance
7.6.1 Attach the front frame to the case with four screws – See figure 18.
7.6.2 Remove the screw from the right side of the battery compartment and pull the compartment
side to the right to allow the wires to be fed through – See fig. 19.
7.6.3 For active appliance side switch as only active switch
7.6.3.1 Detach the plastic battery holder. Route the wires into the battery compartment. Feed the
"L" terminals and connector block through the back right corner of the compartment. Leave
the connector pads in the compartment.
7.6.3.2 Connect the "L" terminals to the control unit.
7.6.3.3 Connect the battery box to the black connection pad.
7.6.3.4 Place the battery box on the "Velcro" pad in the battery
compartment.
7.6.3.5 Refit the compartment side with one screw.
7.6.4 For active remote control without active appliance switch
Caution! Don't connect the batteries in the remote
control receiver until the wires are connected to the
burner control unit. A short circuit could result in
destruction of the electrical components.
The rocker switch should be fitted to the front frame for aesthetic
purposes but leave the wires from the switch disconnected.
7.6.4.1 Route the wires from the receiver through the back right
corner of the battery compartment and connect to the
control unit.
7.6.4.2 Remove the receiver lid. Connect the battery box to the
receiver wires. Fit the four 1.5 V batteries. Replace the
receiver lid.
7.6.4.3 Place the remote control receiver on the "Velcro" pad in
the battery compartment – See fig. 20.
7.6.4.4 Fit the 9V battery to the handset transmitter.
7.6.4.5 Refit the compartment side with one screw.
7.6.5 For active remote control with active appliance side switch
Caution! Don't connect the batteries in the remote
control receiver until the wires are connected to the
burner control unit. A short circuit could result in
destruction of the electrical components
A set of four batteries and battery box is supplied with the
appliance and a further set with the remote control unit.
Only one set is required. The other set can be kept by the owner as
Detach the plastic battery holder.
7.6.5.1
Cut off the "L" terminals from the switch wires on the remote control
7.6.5.2
receiver and remove insulation from approximately ¼" at ends of wires. See
figure 21.
Securely connect the wires to the terminal block. Connect the black wire
7.6.5.3
to the terminal opposite the brown wire. Connect the wire with the
white stripe to the terminal opposite the yellow wire. See figure 22.
7.6.5.4 Route the wires into the battery compartment. Feed the "L" terminals and
connector block through the back right corner of the compartment. Leave the
connector pads in the compartment.
7.6.5.5 Remove the remote control receiver lid. Remove the cover from the white
connection pad. Fit this connection pad to the remote control receiver terminals.
See figure 23.
7.6.5.6 Fit the black connection pad to a battery box. Fit four 1.5V batteries. See figure 23.
Place the batteries and connection pad in the receiver box and replace the lid.
7.6.5.7 Fit the 9V battery to the handset transmitter.
7.6.5.8 Refit the compartment side with one screw.
– See fig. 19
Fig. 19
.
Fig. 20
14
Fig. 18
Figure 21
spares
.
Figure 22
Figure 23