Setting And Checking The Ring Tone; Changing The Ring Tone - AEG D 5000 Instruction Manual

Changing the volume while using a special feature – checking the automatic
messages, playing back memos/messages (including the 8 seconds of waiting period
at the end of the replay), checking and setting of the rings, checking and setting of
day/time, and hearing default message to give technical support to the user - causes
a higher or lower volume for all following messages. Each changing of the volume
will be saved after ending the current operation.
If you are changing the volume while the answering machine is in standby, a signal
tone will demonstrate the current volume. The tone increases if the volume is high,
the tone lowers, if the volume is low. At the point of maximal/minimal loudness, two
short signal tones will sound (maximum for maximal volume, minimum for minimal
volume).

Setting and Checking the Ring Tone

You can set the number of rings before the answering machine answers.
Checking the settings:
Press the key (32) located at the left underside of the base set, while the answering
machine is in standby.
The current setting of the rings will be repeated.
Following list shows the messages belonging to each setting:
The setting is active for both operations:
Recording Mode or Message Only
Number of rings before automatic answer
Message
2 „Zwei Ruftöne" (two rings)
3 „Drei Ruftöne" (three rings)
4 „Vier Ruftöne" (four rings)
5 „Fünf Ruftöne" (five rings)
6 „Sechs Ruftöne" (six rings)
7 „Sieben Ruftöne" (seven rings)
8 „Ach Ruftöne" (eight rings)
9 „Neuen Ruftöne" (nine rings)
„Gebührensparfunktion" (no answering)

Changing the Ring Tone

1. Press the key (32) longer than 2 seconds while standby mode.
2. A beep is heard and the message:" EINSTELLEN RUFTÖNE" (SETTING RINGS)
is displayed. The device is repeating the current ring settings).
3. Press rewind i (27) or fast forward j (25), to set the changes.
4. The settings will be given in the sequence... 4, 5, ..9, "Gebührensparfunktion" (no
answering).
5. Did you find the right setting, confirm with key (32).
6. The chosen setting will be repeated.
39