Getting Started; Location; Setting Up The Base And Handset - AEG Pyramid User Manual

I.

Getting started

1.

Location

You need to place your Pyramid product within 2 metres of the mains power
socket and telephone socket so that the cables will reach.
Make sure it is at least 1 metre away from other electrical appliances to avoid
interference.
Your Pyramid product works by sending radio signals between the handset
and base. The strength of the signal depends on where you site the base.
Putting it as high as possible can help to provide the best signal.
WARNING
Do not place your Pyramid product in the bathroom or other humid areas.
2.

Setting up the base and handset

1. Plug the power adaptor and telephone cable into the underside of the base.
2. Plug the power adaptor into the mains wall socket and switch the power on.
3. Remove the battery cover from the back of the handset and insert the 2 x
AAA rechargeable batteries supplied. Please note the '+' and '-' markings
inside the battery compartment and insert the batteries the correct way
around. Slide the battery compartment shut.
WARNING
Never use non-rechargeable batteries. Only use the approved rechargeable
batteries supplied. Using unapproved batteries will invalidate your guarantee
and may damage the telephone.
4. Place the handset on the base to charge. You should let the batteries
charge continuously for at least 24 hours.
The batteries and handset case may become warm during charging, this is
normal.
5. Once fully charged, plug the telephone line cord into the telephone wall socket.
IMPORTANT
Do not connect the telephone line cord to the telephone line wall socket until
the handset is fully charged and only use the telephone line cord provided.
The base station should be plugged into the mains power socket at all times.
5