Removing A Handset From A Base Set; Selecting A Base - AEG D 5000 Instruction Manual

11. Press the menu key (4).
12. PIN is displayed.
13. Enter the 4 digits of the PIN of this Base Set by pressing the numerical keypad
(default 0000).
14. Press the menu key (4).
15. The Handset is subscribed to this Base.
Subscribing the Handset to Another (GAP compatible DECT) Base
1. The handset is in standby (no tone).
2. Read the Instruction manual of your base to set it to subscribing mode.
3. Continue from item 4 under Subscribing the Handset to a D 5000 or D 7000
Base Set above
.

Removing a Handset from a Base Set

A handset can be deprogrammed from a base set. This feature enables you
to remove a defective handset and to replace it by a new one.
NOTE: You can only remove a handset from a base set with another handset
that is subscribed to the same base.
1. The handset is in standby (no tone).
2. Press the menu key (4).
3. Press the arrow key
4. Press the menu key (4).
5. DATE/TIME is displayed.
6. Press the arrow key
7. Press the menu key (4).
8. SUB PIN is displayed.
9. Enter the PIN code by pressing the numerical keys.
10. Press the program key (4).
11. REMOVE HS — is displayed.
12. Enter the number of the handset (HS1 to HS5) you want to remove by
pressing the numerical keys.
13. Press the menu key B
14. SEARCHING is displayed, then the selected handset is removed.

Selecting a Base

If the handset is subscribed to several base sets, it can only operate on one at
a time. Therefore it has to select a base set.
Automatic Base Selection
The handset will operate on the first base set found.
1. The handset is in standby (no tone).
2. Press the menu key B (4).
16
(11) or (3) until SETTING is displayed.
(11) or (3) until REMOVE HS is displayed.
(4).