Unpacking Information; Wall Tamper Switch Installation; Magnet Cover Installation; Complete Installation - Bosch Radion B810 Reference Manual

8 en | General installation
2.2

Unpacking information

When unpacking the receiver, repeater, or bill trap device, it is important to remove the
cardboard insert as illustrated below;
Figure 2.1: Insert for the receiver and repeater
Figure 2.2: Insert for the bill trap
2.3

Wall tamper switch installation

RADION transmitter devices contain a feature that activates the wall tamper switch located on
the base of the device. In order to properly install the device, you must consider the following:
–
–
2.4

Magnet cover installation

During the installation of the plastic magnet cover, the cover is not designed to be separated
from the base after the base and cover are snapped together. Damage to the plastics may
occur if separated.
2.5

Complete installation

Testing the entire RADION system can only be achieved by performing an area wide test
through the control panel and corresponding keypad(s). This is achieved by performing an
overall service walk test. Refer to your control panel documentation for system-walk, or other
system-wide testing procedures.
2014.03 | 06 | F.01U.261.834
To properly install a device with active wall tamper functionality, insert a screw in the
designated screw slot location.
Failure to insert a screw into the wall tamper slot prevents the wall tamper feature from
generating a tamper signal when the transmitter is pulled away from a wall.
Reference Guide
RADION receiver SD
Bosch Security Systems, Inc.