LE10 Radio Receiver Table of Contents | en Table of Contents Scope of the addendum Units concerned New modes 8 and 9 Connection Connecting ports New mode selection Programming and deleting transmitters Device behavior in modes 8 or 9 Mode indication after power on...
Scope of the addendum Units concerned This document V1.2 is an addendum to the user manual of the LE10 Radio Receiver V1.1. It concerns all LE10 Radio Receivers, marked software version SW1.10 on the product label. New modes 8 and 9 Mode Name...
Connection Connecting ports To open the device: – hold the LE10 Radio Receiver in one hand, facing you, so that you can see the Bosch logo and the two LEDs. – grab the connection compartment housing with the other hand and slide it towards you.
Factory setting is all switches set to off. Programming and deleting transmitters Programming and deleting transmitters in modes 8 and 9 are done as in normal mode 1. See the LE10 Radio Receiver user manual V1.1. F.01U.139.675 | V1.2 | 2012.09...
Device behavior in modes 8 or 9 Mode indication after power on – When the power supply is connected to the LE10 Radio Receiver, the green LED will light up permanently for 2 seconds. Afterwards, the device will display the current mode through the green LED, by blinking as many times as the number of the mode.
LE10 Radio Receiver NOTICE! A N46 transmitter in repeated alarm mode extends the behavior of the LE10 by approximately 26 minutes. If several N46 transmitters are programmed, each activated transmitter stops the sequence and starts its own sequence. Battery-low indication: –...