Programming Wireless Points In The Control Panel - Bosch Radion B810 Reference Manual

Radion receiver sd
Hide thumbs Also See for Radion B810:
Table of Contents

Advertisement

16
en | RADION receiver SD
2
1
s before servicing.
RED
POWER +
36
35
YELLOW DATA BUS A
DATA BUS B
34
GREEN
BLACK
COMMON
33
SDI2 Connector
SDI Connector
RED
32
POWER +
31
YELLOW DATA BUS A
DATA BUS B
GREEN
Figure 3.2: Wiring the receiver to an SDI2 compatible control panel
1 ᅳ SDI2 compatible control panel
2 ᅳ Terminal wiring
3 ᅳ RADION receiver SD mounting base
4 ᅳ Module terminal block
3.3.4

Programming wireless points in the control panel

After completing the physical installation of the RADION system, you must configure the
RADION points in order to establish communication between the RADION system and the
supported control panel. This can be accomplished by using one of two methods:
A "point" can be a detection device, or a group of devices connected to your security system.
The first step to enable communication is to verify that the RADION transmitter is
programmed into the supporting control panel. This is achieved by configuring a point source
index as wireless.
RFID programming from a supported keypad is achieved by two methods;
The preferred method of entering in the RFID number would be to enter it in manually via the
keypad – point source/RFID, or RPS. Doing so gives you greater control and security, while
reducing the risk of incomplete RFID programming.
Not every scenario can be documented regarding various supporting panels and keypads. The
workflow listed below is a generic representation of the programming/enablement process.
Refer to the Points Menu Parameters section inside the Keypad Installer Menu chapter of the
B5512/B4512 and/or D9412GV4/D7412GV4 v2.xx Series Installation and System Reference
Guides, or Points – Point Assignments in RPS Help File for more information.
2014.03 | 06 | F.01U.261.834
R
Y
G
B
Using Remote Programming Software (RPS) on a supported laptop computer, or
Compatible keypad devices to enable your points
Through the point source/RFID menu options, or
Enroll point RFID for wireless points – which uses the "Auto-Learn" methodology.
3
Reference Guide
RADION receiver SD
4
Bosch Security Systems, Inc.

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents