Table of Contents
Advertisement
LE10 Radio Receiver
3
Installation
3.1
Unpacking
The LE10 Radio Receiver is carefully packed for transportation.
The components contained in the box are protected, but should
be handled with care. Store the packaging material for further
use (storage or transport). In case of defective or missing
equipment, do not try to install the LE10 Radio Receiver.
Contact immediately your local representative.
1. Take all components out of the box and place the LE10 Radio
Receiver on the working space.
2. Check that the following accessories are delivered: the
fixings (2 screws and 2 screw anchors) and this user manual.
3. Check that the LE10 Radio Receiver and its accessories have
not been damaged during transportation.
3.2
Connecting the power supply
There are two different ways to connect the power supply of
the LE10 Radio Receiver. After connection, the LE10 Radio
Receiver will be in standby mode.
3.2.1
Power supply with the RJ12 power socket
The LE10 Radio Receiver can be powered by a power supply
unit (PSU). The PSU should be plugged in the RJ12 socket on
the rear side of the unit and should be easily accessible at any
time. See Section 4.1 Connecting ports, page 11 for access to
the socket. See Section 7 Technical data, page 23 for
information about the power supply.
3.2.2
Power supply connected to a wired installation
The LE10 Radio Receiver can be powered by connecting a wired
input into poles 1 and 2 of the connection board. See
Section 4.1 Connecting ports, page 11 for information about the
power supply.
Bosch Security Systems
User Manual
Installation | en
F.01U.278.517 | V2.0 | 2012.11
9
Advertisement
Table of Contents
