Bosch ISW-EN4200 Serial Installation Manual

ISW-EN4200 Serial Receiver
Overview
The Bosch Commercial Wireless ISW-EN4200 Serial Receiver,
powered by Inovonics wireless mesh network technology, connects
Commercial Wireless Sensors to supported Bosch control panels via
the ISW-D8125CW-V2 Interface Module.
These instructions cover installation of the ISW-EN4200 Serial
Receiver. For detailed programming instructions, refer to the
ISW-D8125CW-V2 Installation and Operation Guide
(P/N: F01U161691).
1.0 Installation
Use the provided anchors and screws to mount the ISW-EN4200 in
locations accessible for future maintenance.
For best transmitter reception results, place the
ISW-EN4200 in a central location among the transmitters. If
transmitters are too far away for the receiver to pick up the
transmission, install an ISW-EN5040-T Commercial Wireless RF
Repeater.
For UL Listed installations, install the
ISW-D8125CW-V2 Commercial Wireless Interface
Module within 20 ft (6 m) of, and within the same
room as, the ISW-EN4200.
Mount the serial receiver in a location removed from
metal. Metal objects (duct work, wire mesh screens,
boxes) reduce RF range.
2.0 Configuration
Bosch Commercial Wireless products use a range of radio
frequencies and must be configured for your geographic area.
All selection jumpers are shipped in their default positions
(Figure 1). If you want to keep the default selections, setting the
jumpers is not necessary. The ISW-EN4200 ships configured for
North America frequencies.
Figure 1: ISW-EN4200 Serial Receiver Components
1 - Side cabling knockout
2 - Bottom cabling knockout
3 - Housing release tab
4 - Tamper switch
5 - Reset button
6 - DEC (decode) LED
7 - Frequency Band pins:
-
No jumper = North America (902 MHz to 928 MHz)
-
AUS = Australia (915 MHz to 928 MHz)
-
NZ = New Zealand (921 MHz to 928 MHz)
8 - RX (receive) LED
9 - TX (transmit) LED
10 - Serial data terminal
11 - Serial data port
T
To configure the serial receiver:
1. If the serial receiver is powered on, remove the power source
to reset the serial receiver.
2. Use a small screwdriver to press the housing release tab
(Figure 1). Separate the housing.
3. Place a jumper plug on the appropriate Frequency Band pins
(Figure 1). For North America, remove the jumper plug
(default position).

Installation Guide