Hitachi CL 10SA Technical Data And Service Manual page 25

[46]
[33]
(f) Mounting the assembly to the main body
(i) Insert the Ball Bearing 608VVC2PS2L [20] in the ball bearing chamber of Housing (A) [2] (Fig. 41).
(ii) Press-fit the Third Pinion [35] in the Second Gear [36] and insert it in the Ball Bearing 608VVC2PS2L
[20] of Housing (A) [2] (Fig. 41). At this time, apply grease (Nippeco SEP-3A) to the outer circumference of
the Second Gear [36].
(iii) Mount the Gear Cover [33] to the housing keeping Bracket (A) [54] at the maximum cutting position in the
same manner as the removal procedure (be careful of the spring force) (Fig. 42).
(iv) Tighten the four Tapping Screws (W/Flange) D5 x 25 (Black) [31] and the two Tapping Screws D5 x 35 [55]
(Fig. 42).
CAUTION: Check that there is no scratch, dust or chips on the surfaces of the cam and the roller.
[35]
[36]
[20]
[34]
Fig. 39
Fig. 41
[68]
[67]
Fig. 40
[31]
[52]
[56]
[53]
--- 22 ---
Face the side
where the boss
portion is lower
than the end
surface of the
gear to the
Retaining Ring for
D18 Shaft [48].
[47]
[48]
[47]
Maximum
cutting
position
Fig. 42