Hitachi CL 10SA Technical Data And Service Manual page 22

(c) Power supply unit (Fig. 34)
[12]
[25]
[13]
(a) Mount the Cord [10] to Housing (A) [2] and mount the Cord Clip [11] facing its protrusion to the cord.
Secure them with the two Tapping Screws (W/Flange) D4 x 16 [12].
(b) Push the earth terminal of the Noise Suppressor [8] as far as it will go along the ribs of the Stator [22] and
Housing (A).
(c) Put the internal wire (blue) of the Brush Block Ass'y [25] under the Switch [6].
(d) Arrange the Switch [6] and the Noise Suppressor [8] as shown in Fig. 34.
[8]
[11]
[34]
Earth terminal
Rib
--- 19 ---
[6]
Fig. 34
Blue
[3]
[4]