Preference Settings - Calculated Industries ElectriCalc Pro 5060 User Manual

Preference Settings

Your calculator has the following Pref-
erence Settings that you can access
and change at any time.
Reach the Preference Function by
pressing [Set] [÷]. Then, to access
each category, press the [÷] key until
the desired setting is reached. Within
each category , press the [+] or [-] keys
to toggle between individual selections
(note: the [+] will advance, the [-] will
back-up).
You can change these settings at any
time by repeating the above, and set-
ting in a new preference. NOTE: To
clear preferences, you must either reset
using keystrokes below, or perform an
All-Clear ([Set] [x]).
The Preference Settings are (default
settings shown first):
To Set 1999 or 1996 NEC Code:
[Set] [÷] (1st press of [÷])
[+]
To Set Ambient Temp. to °C or °F:
[÷] (2nd press of [÷])
[+]
To Set Length to Feet or Meter:
[÷] (3rd press of [÷])
[+]
26 — ElectriCalc Pro
CODE 99
CODE 96
AMB° 30 °C
AMB° 86 °F
FEET 1.
MET 1.