Calculated Industries ElectriCalc Pro 5060 User Manual page 18

[VD%] — Percent Voltage Drop
Used to enter or calculate voltage drop.
The default voltage drop is 3%. If wire
size or wire length values are not avail-
able, "nonE" will display since the volt-
age drop cannot be found.
First Press
Enters a maximum allowable voltage
drop percentage (Displays: V DROP
%) or calculates actual voltage drop
(Displays: V DROP).
Second Press
Calculates actual percent voltage drop.
Displays: V DROP %.
[Length] — Length
Enters or calculates the length of a run
for voltage drop computation.
Displays: FEET or MET.
NOTE: Units of length can be set to
Feet or Meters by use of the Prefer-
ence function ([Set] [÷]).
[Set] [Length] — Wire Resistance
Displays the actual resistance per
1,000 feet of the wire size in [WireSz]
based on NEC Chapter 9, Table 8.
Displays: OHMS WIRE.
16 — ElectriCalc Pro