Install The Fuselage Servos - GREAT PLANES Spirit 100 Instruction Manual

❏
4. Fit the rudder to the fin with the hinges. Glue both sides
of each hinge with 3 drops of thin CA.
❏
5. Screw a nylon clevis 15 turns onto both of the 42"
[1067mm] pushrods. Slide a silicone retainer on each of the
nylon clevises.
❏
6. If necessary, bend a slight angle in one of the pushrods
6" [150mm] from the end of the clevis. Slide this pushrod into
the rudder pushrod tube.
❏
7. Align the rudder control horn with the rudder pushrod.
Glue the control horn to the rudder with a small drop of CA.
❏
8. Drill two 1/16" [1.6mm] holes through the rudder.
Secure the control horn with two 2-56 x 3/4" [19mm] SHCS
and the nylon control horn back. Attach the clevis to the
outer hole on the control horn.
❏
9. Slide the second 42" [1067mm] pushrod into the
elevator pushrod tube from the rear.
❏
10. Mount the elevator control horn with two 2-56 x 5/8"
[15.9mm] screws. Attach the clevis to the second from the
outer hole.

Install the Fuselage Servos

❏
1. Make two single sided servo arms that have the outer
hole 1/2" [13mm] from the servo mounting hole. Enlarge the
outer hole with a 5/64" drill bit.
12
5/64" [2mm]
1/2" [13mm]