Finish The Wing - GREAT PLANES Spirit 100 Instruction Manual

❏ ❏
12. Attach the aileron clevis to the outer hole on the
control horn. With the servo and aileron centered mark the
location the pushrod crosses the servo arm. Bend a right
angle in the pushrod at the mark.
❏ ❏
13. Cut the pushrod 1/4" [6mm] past the bend. Push
the pushrod through the servo arm. Retain the pushrod with
the nylon faslink.
❏ ❏
14. Harden the control horn with thin CA and drill out
the second hole with a 1/16" drill. Attach the flap clevis to the
second hole on the control horn.
❏ ❏
radio. Make sure the servo arm is in the position shown in
the sketch. Align the flap with the wing TE and mark the
location the pushrod crosses the servo arm. Bend a right
angle in the pushrod at the mark.
SERVO
HORN
FASLINK
❏ ❏
the pushrod through the servo arm. Retain the pushrod with
2-56 (.074")
the nylon faslink.
PUSHROD WIRE
❏
❏
sketch. Glue the wing joiners together with 6-minute epoxy and
clamp together. Use a paper towel dampened with alcohol to
remove the excess epoxy that has squeezed out of the joiners.
10
15. Plug the flap servo to the flap channel on your
16. Cut the pushrod 1/4" [6mm] past the bend. Push
17. Repeat steps 7-14 for the other wing half.

Finish the Wing

Plywood Joiners
1. Make a sandwich of the wing joiners as shown in the
Aluminum Joiner