10. Installing the light bulbs and glass shade
NOTE: Before starting installation, disconnect the power by turning off the circuit
breaker or removing the fuse at fuse box.
ATTENTION: The Energy Policy Act of 2005 requires this fan to be equipped with
a 190 watt limiting device. If lamping exceeds 190 watts, the ceiling fan's light kit
will shut off automatically.
1.
Install 3 x 40W
candelabra
2. Remove the 4 screws from the glass shade assembly.
shade assembly close to the mounting plate and secure with the screws
previously removed.
(Fig. 18)
3. Restore power, your light kit is ready for operation.
bulbs ( included).
Raise and hold the glass
Bulbs
Figure 18
Screws
Mounting
plate
Glass shade