Finishing The Installation; Blade Installation - HAMPTON BAY 132 cm Fan User Manual

Outlet box
Black (hot)
Black ("AC IN L")
Receiver
Black ("to motor L")
White ("to motor N")
Blue (for bottom light)
Orange
Ground
(for upper light)
(green)
Blue (for bottom light)
Black (motor)
Orange
(for upper light)
Fan
Figure 13
6. Finishing the
Installation
White (neutral)
Step 1.
Green or bare
copper (ground)
hanger bracket.
White ("AC IN N")
Step 2. Slide the canopy up to ceiling and over
the screw on hanger bracket. Rotate canopy
clockwise and tighten the screws. Next, while
holding the canopy with one hand, slide the
canopy cover over the screws and rotate
(Connect to
ground wire on
clockwise until tight. Note: adjust the canopy
hanger bracket
if no house
screws as necessary until the canopy and
ground wire
exists.) canopy cover are snug. (Fig. 14)
White (neutral)
Outlet box
Hanger
bracket
Hanger
ball
Figure 14
Remove 1 of 2 screws from the
Canopy
Canopy
cover

7. Blade installation

Rotate motor until holes become visible
through the motor access window. Align the
holes from the blade to the holes from the
motor and secure in place with screws and
fiber washers provided. (Fig. 15)
Figure 15
Blade
Access
window
Fiber washers
Screws