Hanging The Fan 4 - HAMPTON BAY 132 cm Fan User Manual

REMEMBER to turn off the power.
Follow the steps below to hang your fan
properly:
Step 1. Secure the hanger bracket to the
ceiling outlet box using screws included
with your outlet box, lock washers
included with the fan. (Fig.5)
Step 2. Loosen the two set screws and
remove the hitch pin and lock pin in the top
coupling of the motor assembly. (Fig.6)
Step 3. Remove hanger ball from downrod
a s s e m b l y b y l o o s e n i n g s e t s c r e w,
removing the cross pin, and sliding ball off
rod. (Fig.7)
Step 4. Carefully feed fan wires up
through the downrod. (Fig. 8) Thread the
rod into the coupling. Next line up holes
and replace lock pin and hitch pin. Tighten
set screws.
Step 5. Slip coupling cover, canopy cover
a n d c a n o p y o n t o d o w n r o d . ( F i g . 9 )
Carefully reinstall hanger ball onto rod
being sure that cross pin is in correct
position, set screws are tighten and wires
are not twisted.
Step 6. Now lift motor assembly into
position and place hanger ball into hanger
bracket. Rotate until the check groove has
dropped into the registration slot and seats
firmly. (Fig. 10) Rod should not rotate if
this is done correctly.
Outlet box
Hitch
pin
Hanger bracket
Figure 5
Figure 6
Cross pin
Downrod
Hanger
ball
Supply
wires
Downrod
Figure 7 Figure 8
Hanger ball
Set
screws
Coupling cover
Lock
pin
Lock pin
Figure 9
Registration
slot
Figure 10

Hanging the Fan 4.

Downrod
Canopy
Canopy cover
Set screws
Hitch pin