Getting Started; Resetting The Unit; Preparing The Card Remote Commander; Setting The Clock - Sony CDX-H905IP Operating Instructions Manual

Getting Started
Reseltilg
the unit
Before operating the unit for the first time, or
after replacing the boat's battery or changing the
connections, you must reset the unit.
Open the front panel and press the RESET button
with a pointed object, such as a ball-point pen.
To display the clock, press
(DSPL).
Press
( DSPL)
again to return to the previous display.
Tip
You can set the clock automatically with the RDS
feature (page 13). (CDX-HR905IP only)
Inserting the disc in the unit
1
Slide the OPEN switch in the direction
of the arrow.
Before using the card remote commander for the
first time, remove the insulation film.
Note
Pressing the RESET button will erase the clock setting
and some stored contents.
•
4
Close the front panel.
Playback starts automatically.
Notes
• Do not put anything on the inner surface of the front
panel.
• Be sure to close the front panel during operation.
2
Open the front panel.
3
Insert the disc (label side up).
/ '
.........
c
'0
'-
Preparing the card remote
commander
RESET
button
Tip
For how to replace the battery, see "Replacing the
lithium battery of the card remote commander" on
page 20.
Setting the clock
CDX-H905IP:
12-hour indication
CDX-HR905IP:
24-hour indication
Ejecting the disc
1
Slide the OPEN switch and open the
front panel.
2
Press~.
The disc is ejected.
3
Close the front panel.
1
Press and hold
(SELECT).
The setup display appears.
2
Press
(SELECT)
repeatedly until
"CLOCK-ADJ" appears.
3
Press
(SEEK)
+.
The hour indication flashes.
4
Rotate the volume control dial to set
the hour and minute.
To move the digital indication, press
(DSPL).
5
Press
(SELECT ).
The setup is complete and the clock starts.
7