Marine remote commander: RM-X55M,
BUS cable (supplied with an RCA pin cord):
RC-61 (I m), RC-62 (2 m)
CD changer (10 discs): CDX-757MX
CD changer (6 discs): CDX-T7OMX, CDX-T69
Source selector: XA-C40
AUX-1N selector: XA-300
HD Radio™ tuner: XT-IOOHD
Accessories/equipment other than the marine
remote commander RM-X55M/X11 M are not
waterproof. Do not subject them to water.
Your dealer may not handle some of the above listed
accessories. Please ask the dealer for detailed
US and foreign patents licensed from Dolby
MPEG Layer-3 audio coding technology and
patents licensed from Fraunhofer US and Thomson.
This product is protected by certain intellectual
property rights of Microsoft Corporation. Use or
distribution of such technology outside of this
product is prohibited without a license from
Microsoft or an authorized Microsoft subsidiary.
This unit cannot be connected to
or an equalizer which
Sony BUS system compatible.
Design and specifications are subject to change
• Halogenated flame retardants are not used in the
certain printed wiring boards.
• Halogenated flame retardants are not used in
• Packaging cushions are made from paper.
The following checklist will help you remedy
problems you may encounter with your unit.
Before going through the checklist below, check the
connection and operating procedures.
No power is being supplied to the unit.
• Check the connection. If everything is in order, check
If the unit is turned off and the display disappears, it
cannot be operated with the remote commander.
-Turn on the unit.
The power antenna (aerial) does not extend.
The power antenna (aerial) does not have a relay box.
• The volume is too low.
• The ATT function is activated, or the Telephone ATT
function (when the interface cable of a telephone is
connected to the ATT lead) is activated.
The position of the fader control "FAD" is not set for
a 2-speaker system.
The CD changer is incompatible with the disc (MP31
Play back with a Sony MP3 compatible CD
changer, or this unit.
No beep sound.
The beep sound is canceled (page 16).
• An optional power amplifier is connected and you are
not using the built-in amplifier.
The contents of the memory have been erased.
The RESET button has been pressed.
Store again into the memory.
The power supply lead or battery has been
• The power supply lead is not connected properly.
Stored stations and correct time are erased.
The fuse has blown.
Makes noise when the position of the ignition
The leads are not matched correctly with the boat's
accessory power connector.
During playback or reception, demonstration
If no operation is performed for 5 minutes with
"DEMO-ON" set, demonstration mode starts.
-Set "DEMO-OFF" (page 16).
The display disappears from/does not appear
in the display window.
• The dimmer is set "DIM-ON" (page 16).
The display disappears if you press and hold
Press and hold
on the unit until the
The Auto Off function does not operate.
The unit is turned on. The Auto Off function activates
after turning off the unit.
Turn off the unit.