SAFETY PRECAUTIONS • This unit should only be used on a level surface and is intended for indoor use only. XMARK Fitness recommends an equipment mat be placed under the unit to protect the floor or carpet and for easier cleaning.
This manual will guide you through the assembly process. If at any time you are having trouble with the assembly or use of this product, then please contact us at our XMARK Fitness help line. We have trained service technicians on site to take care of you, our valued customer.
Page 6
Assembly NOTE: Hand tighten bolts and Nylon Lock nuts until machine is fully assembled. Step 1 Connect Main Base (#1) to the Rear Base (#2) using: • two M10*80 Button Head Cap Screw (#34) • four Φ11*Φ20*2 Flat Washer (#31) •...
Page 7
Assembly NOTE: Hand tighten bolts and Nylon Lock nuts until machine is fully assembled. Step 2 Slide Weight Bumppers (#24) and Slide Weight Support (#12) onto guide rods (#9) as shown. Connect Upright (#3) to the Main Base (#1) using: •...
Page 8
Assembly NOTE: Hand tighten bolts and Nylon Lock nuts until machine is fully assembled. Step 3 Slide Top Cross Frame (#5) on top of Guide Rod (#9) and secure using: • two M10*25 Button Head Cap Screw (#36) • two Φ11*Φ20*2 Flat Washer (#31) Attach Top Frame (#4) to the Upright (#3) using: •...
Page 9
Assembly NOTE: Hand tighten bolts and Nylon Lock nuts until machine is fully assembled. Step 4 Start by attaching the High Pully Cable (#15) to Slide Weight Support (#12) using: • one 1/2"-12 Jam Nut (#44) Attach one Big Pulley (#21) to the Top Frame (#4) using: •...
Page 11
Assembly NOTE: Hand tighten bolts and Nylon Lock nuts until machine is fully assembled. Step 5 Complete leg hold down assembly using: • one Roller Pad Frame (#10) • two Foam Padding (#30) • two Plastic Washer (#42) • two Metal End Cap (#43) Complete Seat Pad (#20) assembly using: •...
Assembly NOTE: Wrench Tighten above all bolts and Nylon Locknuts. Step 6 Silde two Adapters (#50) to the Slide Weight Support (#12) and secure using: • two M8*6 Screw (#49) For standard plate do not slide the Adapters (#50) on, just using two Spring Clip (#56) hold the plate off from the Slide Weight Support (#12).
Parts List XM-7618 Parts List Ref # Part # Description P00279 Main Base P00280 Rear Base P00449 Upright P00450 Top Frame P00451 Top Cross Frame P00452 Seat Support P00453 Seat Pad Tube P00676 Lat Bar Hook GYM P00454 Guide Rod...
VALID ONLY if the product is assembled / installed according to the instructions / directions included with the product. • In a light institutional setting, XMARK Fitness will extend a one year limited parts warranty and a lifetime frame warranty to the original purchaser.
Need help?
Do you have a question about the XM-7618 and is the answer not in the manual?
Questions and answers