Advertisement
OPERATING THE REMOTE
MAINTENANCE
The MAGNUM 800 is designed and constructed to give a long and trouble-free service
life.
However, like all equipment, it will benefit from regular simple maintenance.
Keep the following points in mind:
• If fluid is spilt onto the casework of the machine it should be cleaned with a damp cloth
(disconnect the power supply before doing this).
• Do not use solvents to clean the casework of the machine as this may remove the silk
screen printing.
• Only use JEM / MARTIN fluid in the machine. Other fluids may cause damage to the heat
exchanger and other components.
• Keep the cables in good condition.
Timer Control and LED
The timer is switched on by rotating the Timer control
clockwise until the green Timer LED is on. At this point the
repetition rate of the timed pulse is minimum. Rotating the
control clockwise causes the repetition rate to increase. The
duration of the pulse is fixed, only the frequency can be
changed. When combined with the output level control this
provides a simple way to maintain a constant level of fog.
Fog Switch
Press the fog switch at any time (the Ready LED must be on)
to get fog output at the level currently set with the level control.
Ready LED (Green)
When the machine is up to operating temperature and capable
of producing fog, the Ready LED is on.
Heat LED (Red)
The Heat LED is on when power is being supplied to the heat
exchanger. When the maximum operating temperature is
reached the LED is off.
Output Level Control
The output level is rotated clockwise to increase the fog output
level. Remember that the machine has 'Pump Ramping' so that
the output level will automatically reduce as the heat
exchanger cools, thus allowing longer run times.
5
Advertisement
