SOLTEK SL-75MIV User Manual page 69

Init Display First This option allows you to decide to activate PCI Slot
IDE HDD Block Mode Block mode is also called block transfer, multiple
Onboard FDC
Controller
Onboard Serial
Port 1 / Port2
UART 2 Mode This item allows you to select which mode for the
IR Function Duplex This item allows you to select the IR half / full duplex
TX, RX inverting
enable
Onboard Parallel Port This item allows you to determine onboard parallel
or AGP first.
The choice: PCI Slot, AGP.
commands, or multiple sector read/write. If your IDE
hard drive supports block mode (most new drives do),
select Enabled for automatic detection of the optimal
number of block read/write per sector the drive can
support.
The choice: Enabled, Disabled.
Select Enabled if your system has a floppy drive con-
troller (FDC) installed on the system board and you
want to use it. If you install add-in FDC or the system
has no floppy drive, select Disabled in this field.
The choice: Enabled, Disabled.
Select an address and corresponding interrupt for the
first and second serial ports.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/
IRQ3, Disabled, Auto.
Onboard Serial Port 2.
The choice: Standard, HPSIR, ASKIR
function.
The choice: Half, Full.
This item allows you to enable the TX, RX inverting
which depends on different H/W requirement. This
field is not recommended to change its default set-
ting for avoiding any error in your system.
The choice: "No, No", "No, Yes", "Yes, No", "Yes, Yes".
port controller I/O address setting.
The choice: 378H/IRQ7, 278H/IRQ5, 3BC/IRQ7,
Disabled.
75MIV
69