Set-Up Menu - ABB AW400 Series Instruction Manual

The Channel definition menus are in accordance to the number of the channels installed (e.g. if only Channel
1 is installed, only Channel 1 definition menu appears; if two channels are installed, both Channel 1 definition
menu and Channel 2 definition menu will appear. The same principle applies for Channel 3).
Select the type of channel according to the sensor installed (see glossary 2.2 for the symbols used).
NOTE: At power-up, the instrument loads data in memory according to the last channel definition.
When the Channel definition is modified, in order to have the new data properly stored, it is necessary
to exit the Channel definition menu and return to the operation menu (END key), switch-off power to the
instrument, then power it up again while keeping key 9 (CANCEL) pressed.
If the language selected was different from Italian, it is necessary to select again the desired language,
as this operation sets back instrument to default English language.

4.4 Set-up menu

The set-up menu is structured in three different submenus and namely:
•
Configuration
•
Output settings
•
Alarms
Each of them will be discussed in detail in the following pages.
Operation display
Process
Password
XXXXX
1,2,3....
Menu
Configuration
To enter
Configuration:
(See Par. 4.4.1)
to set the general operating parameters of the instrument, see 4.4.1;
to select 4–20 mA or 0–20 mA output for each channel, see 4.4.2;
to set alarms level; see 4.4.3.
Calibration
Output Setting
To enter
Output setting:
(See Par. 4.4.2)
Channel definition
Alarms
To enter
Alarms setting:
(See Par. 4.4.3)
25