Re-Assembling The Rascal Autogo; Illustration 16 - Align Rear Frame To Drivetrain; Align Rear Frame To Drivetrain Frame - Rascal AutoGo Owner's Manual

Re-assembling the Rascal AutoGo

Putting the Rascal AutoGo back together involves re-attaching the drivetrain, re-positioning the tiller and dash, raising &
locking the seat frame, installing the seat, and installing the battery pack for driving operation. Instructions to re-assemble
the Rascal AutoGo are provided in this section.
1. Place drivetrain on firm, level surface with drivetrain
kickstand facing the front of the Rascal AutoGo.
2. Position rear of frame over top of drivetrain so that slots
in the rear of the frame align with struts of the drivetrain,
as shown in Illustration 16. Lower rear frame onto
drivetrain, then release. Push down on rear of frame until
drivetrain clicks into position.
Removing or replacing Quick Release Drivetrain may present a pinch hazard. To avoid
accidents or injuries be sure to keep hands free from labeled pinch points.
Rascal AutoGo Owner's Manual
Illustration 16 - Align Rear Frame to Drivetrain Frame
WARNING!
EMC Part: 19286400 Rev.01 03/09/07
34